HAUTMEC Tube Bender,90 Degree 3-IN-1 pipe bender for 1/4" 5/16" 3/8" Copper Aluminum and Brass Pipes HT0004-PL

I had to replace a pipe that was pretty close to the wall, the cutter I had was too big so I got this one and it worked great, very easy to use and made nice clean cuts.

Worked great, seems rugged and sharp. Operated as expected. Would by again!

Looks great thanks Amazon 😊

I had to remove a valve from a line that was run along a floor joist. This tool was able to fit in a very tight place and get the job done. I then made three subsequent cuts; each of which took a little longer so I don't think this tool is right for a big plumbing job but it did what I asked of it.

Doesn't cut through, leaves a groove on 1inch copper pipe, the cutter doesn't rise up to cut through. I know which direction is correct, no need to suspect that. I already got the 1/2 & 3/4 in other brand. Bought this 1inch one last October after a project using a twist knob tightening cutter in confined space, and 1st use this April... Contacted the seller, no reply at all. So don't expect warranty, 0. Update: After this review, the company contacted me and sent me a replacement which works, don't know the reason why the 1st one doesn't rise up to cut through, weak spring? Anyway, all truth.

Far quicker and easier than the older screw style cutters.

It works in tight spaces

I was cutting a T out of a copper pipe and replacing it with a sharkbite, so I needed to make a few cuts. I practiced cutting with a spare piece of pipe, then got the T out with two cuts. I realized the gap was too small and I needed slightly more room to effectively splice in, so tried to make more, but the cutter kept spinning and spinning but doing nothing. It seemed like the spring had perhaps come loose somehow and wasn't providing enough pressure against the pipe. I tried pushing the spring back, to no avail, then worked to take apart the cutter to replace the blade or reset the spring position, but the screws easily stripped out and were very difficult to remove. I gave up and bought a manual cutter from Ridgid, which worked great. This device was awesome for a couple cuts... but that was it.

Pipe cutter it works well. I cut factory steel brake line with it.

My life saver as I need it badly to cut my wardrobe rail that I purchased but was too long. Easy to use and worked perfectly

Replacing brake lines on an old caddy. It did the trick. Worked well and made nice bends

It's to big to use on 25mm copper To small for 32mm. Might work on gas pex etc but haven't tried that yet.

i wanted a pipe cutter that was small but able to do both 10mm and 15mm it seemed expensive to buy 2 of those pacman shaped auto cutters because they only do fixed sizes. found this and its ideal for both sizes and anything in-between! its smaller than your average pipe cutter works well on 10mm and 15mm pipe even though it may take longer to cut than those auto cutters but i can live with that. sized perfectly just the right size for the job especially when you are cutting in tight quarters. highly recommend!