Mud Flaps Kit for 2018 2019 2020 Volkswagen VW Atlas Mud Splash Guard Front and Rear 4-PC Set by TOPGRIL

If you have a VW Atlas but this! Same as the OEM mud guards! Easy to install! You just need to drill 2 small holes in the front ... no big deal. Trust me .. love it!

Front install was easy, turn tire direction to make space for tools, the wheel well trim on the 2019 VW Atlas is plastic. On the front Use the OEM screw at the bottom in the well to start, then drill a tiny pilot hole 1/16 drill bit on the edge of the trim for 2 holes, avoid drilling deep. There is no metal to drill thru. You can reuse the factory screws. I have side steps so the front very bottom screw was a little difficult to drill. Use a washer. Drive the screws by hand so as not to strip the holes. You will need a T25 torx and phillips screwdriver. On the rear i dod not remove the tire, no need using a long drill bit extension and got around the tire. On the rear i used the 2 existing screws to start, and drilled a 1/16 in the top hole of the flap and secured it into the edge of the trim. On the rear bottom take out the bottom screw holding the oem trim. It was to short to reuse. I used a washer and 1 1/4 stainess screw from my collection to secure the bottom of the flap. Make sure to use a flashlight to locate the bottom hole drive in by hand. Again save all the screws you will need them. DRIVE ALL SCREWS BY HAND, ITS ALL PLASTIC AND WILL STRIP.

Didn't show up as advertised

Product is fine, some instructions would be helpful. Read a RVW on the product where the fellow explains drilling 2 small holes in front - spot on instruction!

this one is aftermarket.... But fits very well on my Volkswagen 2022 Atlas.

Very good product. Makes my VW Atlas look nicer. Great mudflaps. Easy to install Very inexpensive also

Fastening holes are at random places, cannot be installed on Atlas without working with a drill

Good fit, you have to be careful when you line up for holes. Also got the “used” saved a ton and they were impecable!

جودة ممتازة

Embonan casi bien. Los delanteros no embonan totalmente, quedan unas partes sin hacer contacto con la lámina interior de la salpicadera y hay que usar un tornillo largo para que quede bien. Este tornillo no lo trae el producto, hay que usar el que estaba puesto en el auto. Las traseras embonan bien, pero no tiene los hoyos para tornillos en el lugar correcto, hay que hacerlos. El producto es bueno, y después de superar los problemas de instalación quedan bien y hacen su función. Nada del otro mundo.