Upgraded Plug-in Motion Activated Light Control, Souphran Wireless Motion Detector and Plug Set, No Wiring, Adjustable Detection Range, Always-on Timer and Light Sensor, (1 Pack-new)

Worked as expected. Was very sensitive Easy pairing. I wall mounted motion sensor next to light switch which controlled the ceiling fan. The motion sensor was used to turn on/off a table lamp

Took 24hrs to tinker and fine tune the adjustments. Will pickup motion 20yds and then reset. I have the reset going at 1-minute. With this control I am using a GREEN STROBE light. Motion triggers the electrical plug and I have a 110v traffic strobe plugged into that. A SILENT but immediate notification. Without the BEEP BEEP BEEP that most people hook up as SOUND. I went thru a dozen other sounding driveway monitors that anytime a person or vehicle sets off motion detector, the beep made my dogs go ballistic. However, I would suggest using the 3-dip switches "as they are" and "fine tune" AFTER you see this motion signal in use. Product shows turning lights on and off. I just use it as backup security for area covered.

Works great but a little too sensitive. When the AC kicks on the kitchen lights do to, kind of annoying when that happens at 3 in the morning. Other than that, great product.

They work great. I have a LED rope/ strip under my elevated bed. Turns on and off very well.

Clamshell will not go back together. Very hard to read the dials for setup. Dials should be accessible from rear, since once you open it will not shut properly. It works, but if it comes apart and crashes to floor after mounted does it really work. I like that it uses AA batteries. but all feature should behind a smaller cover, not have to take completely apart and not go back together. Rechargeable batteries are worse as they are slightly larger, then they shell hits them and will not shut at all. Slimmer AA work, but shell clasps still too week to hold it together properly. See video

Home Depot sells a GE unit that shuts off after 10 minutes, even if you are right in front of the sensor moving around. It comes back on in a few seconds, but it is annoying. This unit is far more intelligent. As long as it detects motion, the light stays on continuously and only shuts off after 10 minutes of no motion. If you already have another light on in the room, the unit won't turn on. But if the sensor light is on first and then you turn on another light, it will continue to keep its light on as long as it detects motion. This makes it great to use for controlling the lights over the kitchen sink. When I walk in the kitchen, I have instant light. It stays on as long as I'm in the kitchen. I can turn on additional lights to work without affecting this light. This is exactly what I was looking for. I highly recommend this unit.

I’m using Siri to write this please excuse any strange words. I have extremely low vision and find myself wandering around in the kitchen trying to find out where things are. I put this on the corner of the table, which is next to the refrigerator and now when I get close, it lights up and it gives me a point of reference. It’s simply excellent. It’s easy to install no strange things just slap the batteries in and go. I did the whole process in about five minutes without reading any directions and the light comes on it works very well. I’m very very glad to have it and will probably purchase more as my vision becomes worse. Thank you for taking the time to read my Review But if you know somebody with low vision, I think they would love this. It just brightens up your day :-)

These work really well, I'm overall impressed. It could use some improvements... You need to remove the cover to adjust the delay, the sensitivity, etc. That can make it a little tricky to put back exactly where it was, depending on how you have it set. But there is still lots of good features in these. I do very much like the magnetic base with gymbal adjustability. That makes it easy to mount and aim it pretty much anywhere you need it. The 2-head set comes with a couple self-adhesive metal circles that you can stick on a well-prepared surface (cleaned first, and then wiped with alcohol!) so it can go wherever you need it. The socket module you plug into the outlet is of reasonable size, it doesn't hog the outlet space like some of the other AC-remote control setups do available on this site. The AA battery capacity means you can use your own rechargeable batteries, and my first set of NiMH AAs in put in this are still going strong after 2 months of high-traffic use. You can set it up the two heads so that both can control one socket, while one of the sensors can control a second socket. Can be a neat solution to some mixed traffic-intersection and multi-circuit challenges, e.g. great for zone lighting! Def will buy again as needs arise.