RTD PT100 Temperature Sensor Probe(0.23"x 2“), 1/2" NPT Thread with 2 Meter Cable,-50 to 300 ℃

Use these as part of a Brewing Mash Temperature controller. Temperature jumps up and down 1-2 Degrees F, so not so great for an OCD perfectionist that wants to hold temperature exactly as programmed. Works but indicated temperature takes a long time to stabilize.

This is a 4 pin connector , I needed a three pin, and was led to believe this is a 3 pin arrangement Waited weeks for the wrong part. Quite disappointed Upon inspection of the part, there is a missing fastener and the part looks like it was not finished at the assembly line. This needs to go back . Don’t recommend purchase from this vendor

I purchased this for my brew kettle and it did not work with my PID using the correct settings for the RTD PT100 and it shows the probe as failed. I should have known the price was to good to be true.

After isolating from everything I could imagine would interfere, I still get some "jumpy" temp readings. Tried a friends better brand name and they worked. These will work in a pinch but looking to upgrade soon.

Couldn't beat the price so I thought I'd try it. It arrived on the slow boat from China about a month after I purchased it. I wasn't in a hurry so no big deal. Packaging was good. Was only 1 degree off. Only issue i can see is the threads are not tapered enough, threads all the way into fitting. Requires lots of tape and thread sealant for it to not leak.

Advertised as a 3-wire probe but came with a 4-pin connector.

Used this for a raspberry pi project and the sensor reads 3 degrees off with ice water and then reads 16 degrees off at boiling temps do not buy!!!!!!

Does what it is supposed to do, which is read temperature. What it does that it shouldn’t do is leak through a pinhole along the weld at the base of the probe.

Parfait

Reads the temperature fine. Unfortunatly it leaks because the weld is not complete.