EANOSIC Solid Carbide Single Flute End Mill 1/4” Shank, Upcut CNC Spiral Router Bit O Flute Milling Cutter for Aluminum Plastic Acrylic PVC MDF

This worked great. The big was excellent for engraving. We bought extra just in case, though they lasted much longer than expected. High quality, would definitely buy again.

If you are going to be cutting acrylic material I would recommend trying this bit. I never realized how much difference the Oflute bit can make. I was trying to use a 1/8", up cut, 2 flute end mill to cut some 1/4" thk. acrylic material. It worked so long as I was cutting small pieces one at a time. The first time I tried to cut bigger pieces with longer cuts it overheated and melted the material and just made a mess. I got this bit and tried it at 18000 rpm with 100" per minute travel speed and 1/4" depth per pass. it worked remarkedly well but it left a slightly rough (scalloped) edge. I slowed the travel speed to 80" per minute and reduced the pass depth to 3/16" per pass and it cut extremely well and left a very smooth edge. I am going to order another one of the 1/4" bits and also (2) 1/8" bits. I don't know how well these work in other materials but right now I am cutting a fair amount of acrylic. I am going to experiment with these bits on some aluminum as well as wood just to see what they will do.

This carbon bit worked flawlessly first time use. I used it to cut aluminum composite sheets. It worked perfect to make the bend in the sheets

Nice, consistent bits with a coating that is intended to reduce heat buildup and extend the life of the cutting edge. The bits are machined consistently. Nice spirals, consistent cutting edges and a sharp tip on each. Polished shafts, really good attention to detail for the price point.

I am amazed, and very pleased with his bit! I used it to rout two channels in 1/4" Plexiglass. It cut fast, and smooth, with NO chatter or tearing. I will use it on other materials, but for now- it's my go -to bit for plexiglass! HIGHLY recommended!

Had a cnc job that needed to cut 1 inch deep profile. My mill only has 4750 rpm so was worried how this single flute design would work. Ran multiple 1/4" deep passes at 25 in/min. Chips came out clean, no melting of clogging, surface finish good. Only down side is can't plunge cut.

Garbage, broke after second time I used it, I even dialed back the speeds & feeds & step down because it's such a small (1/32") bit. Do not buy it!

Got this bit to cut acrylic on the CNC. It cuts very well and cleanly so that is a plus. However, this bit is not 1/8" diameter. I spent a great deal of time dialing in settings and design for a piece that required high precision and was becoming very confused as to why I was not getting the as-designed dimensions for pockets and holes and wondering why I was having to modify the design with larger circles than what were being cut so that I could get the required dimensions. Then I measured the bit -- it is 0.1125" diameter rather than the as-stated 0.125" diameter, a full 10 mils off the nominal dimension. I was able to compensate but this is not an acceptable practice. If the bit is 2.85 mm, sell it as 2.85 mm, not as 1/8". I now have a very bit-specific design and tool path because of this.