Fibaro FGB-002 Dimmer Bypass 2, Black

Mein Fibaro funktionierte mit dem Leuchtmittel nicht. In Kombination mit dem Bypass klapps. Gut, dass es sowas gibt

Inget övrigt att önska, gör det den ska!

Se ajusta a la descripción del producto y funciona correctamente

If you need to fix ghosting (LED lights stay slightly on) when you fit a smart dimmer, then this does the job perfectly. My living room has 14 5W LED downlights, and had a standard rotary dimmer. The downlights were fitted years ago by a previous owner, and are builders merchant cheap no-name ones which also flickered badly when dimmed. I wanted to add smart control, to integrate with my Hue bridge and other lights. Replacing all the fittings with fire rated GU10 cans and smart bulbs, or even just normal LED bulbs would cost way too much. No neutral wire at the light switch, as usual for older UK fittings. So I fitted a candeo zigbee rotary no-neutral trailing-edge dimmer switch (which looks identical to the old dimmer, so happy wife), which works fine for switch/voice/app control. However, as it still draws a little power to run the switch itself when lights are off, the only route to neutral is through the LED lights - and that means that when the switch is off, that small draw is enough to light an LED or two faintly. Better LED downlights might not have this problem, but that means replacing all the fittings and bulbs, which I'm trying to avoid. I tried a different dimmer bypass (which didn't work) but this fibaro bypass works perfectly, I just wired in parallel at the first downlight. As a bonus it also stabilises the downlights better at low power, so I was able to set the dimmer minimum level two clicks lower while still allowing all the LEDs to turn back on fully with no flicker. A few hundred pounds for 14 downlight cans and bulbs to have smart lights without ghosting, or pay an electrician to run a neutral to my dimmer switch via a tricky duct; or this £10 bypass in the ceiling inside the junction box. I know which I'm happier with! Obviously, enough knowledge (and a detector pen) to do basic DIY with mains electric wiring safely is required, and only install when the breaker is off; or get an electrician.

Produit indispensable si on souhaite domotiser des lumières LED extérieur avec une prise connectée. Permet d'éviter le clignotement des lampes avec le résidu de tension de la prise même éteinte. Je recommande