KingTool 4-Piece 1/2-Inch Drill Chuck Set with Key and Morse Taper Arbors | Includes JT33-MT1 and JT33-MT2 arbors, 1/32-1/2-inch clamping range and 0.005-inch accuracy for lathes and drill presses.

This is a great value for the money. I used mine it for drilling holes in pen blanks on my lathe. Already made several pens and it has worked flawlessly.

Fits very well into my wood lathe. Very stable fit, nice and heavy which to me means good quality and durability. Works quite well also.

Works great on my Laguna 1524 lathe. I use it all the time.

well made and works well

well made, accurate machining,M-taper fits well, chuck goes to zero to fit tint drill bits.Lube it and use it.Does not have a drive tang and may be difficult to change out.

So far, it’s worked great! No complaints

Perfect replacement for a 30 year old Delta drill press

I bought this chuck because the one on my drill press have a big, worn-out chuck with about .006 in. of run-out at the bit and I wanted better. At first I was not happy with the .004 I was getting, but tried resetting the arbor at four points (0,90,180, and 270 degrees) until I go the best runout reading then did the same with the chuck. At the end of the process I measured (several times to be sure) and was getting well below 0.001 in. run-out at the bit. I don't know what is "good" for drill press chuck runouts, but I am very happy to go from .006 to .001 for $33.

Works. Well